In fact, any kind of antioxidant can not fully meet these conditions. Therefore, in actual application, it is often based on the variety, use and processing method of engineering plastics, using the strengths of various additives and cooperating to produce synergistic effects.

Antioxidant is a kind of chemical substance. When it is only a small amount in the polymer system, it can delay or inhibit the progress of the polymer oxidation process, thereby preventing the aging of the polymer and prolonging its service life. It is also called " Anti-aging agent".

Common tetra-group lead, ferrocene, MMT (methylcyclopentadiene trikarbonyl manganese) or CMT is common, because metal deposits can occur in the inside of the launching machine, resulting in a cylinder wear, spark plug ignition Poor problems such as poisoning, oxygen sensors and ternary catalysts, have been prohibited or constrained. The addition of tetra-element and ferrocene added is known as national standards, and the manganese-based anti-explosive agent is strictly constrained (the detection limit is less than 0.018 g / L).

The octane is the most important quality indicator of the vehicle gasoline.

Chemical nature: Forbidden qualitative: strong oxidizing agent, strong reducing agent, strong acid, strong base. Ecological nature: Ecotoxicity EC50: 1.2 ~ 1.51mg / L (luminous bacteria, microtox toxicity test) Biodegradability Miti-I test, initial concentration of 100 mg / L, sludge concentration 30 mg / L, 2 weeks later degraded 77%. Non-biodegradability In the air, when the hydroxyl radical concentration is 5.00 × 105 / cm3, the degradation of the half-life is 7.8d (theory). Other harmful effects The material is damaged by the environment and should pay spe

A substance that can reduce the surface tension of water, solution, suspension, etc., prevent the formation of foam, or reduce or eliminate the original foam. [1]

Light yellow to white granular crystals (semi-circular) white to light yellow loose crystals, heating is made black.

From the perspective of physics, the methods to eliminate foam mainly include placing baffles or filters, mechanical stirring, static electricity, freezing, heating, steam, radiation, high-speed centrifugation, pressure and decompression, high-frequency vibration, instantaneous discharge and ultrasonic (acoustic) Liquid control), etc., these methods promote the gas permeation rate at both ends of the liquid film and the drainage of the bubble film to varying degrees, so that the stability factor of the foam is smaller than the attenuation factor, and the number of foams is gradually reduced.

1.4, 4 '- methylene bis (2-chlorocene) The molecular weight is 267.15, the molecular formula is C13H12N2 CL2

Phosphorus pentachloride is mainly used as a chlorination reagent for alcohols, carboxylic acids, amides, aldehydes, ketones, enols, and Beckmann rearrangement reagents. It is used as a chlorination agent and catalyst in organic synthesis, and is used in the production of medicines, dyes, and chemical fibers. It is also the raw material for the production of phosphazene chloride and phosphorus oxychloride.

Aspirational antioxidants should have the following conditions: ①Should have high anti-oxidation ability; ②Good compatibility with resin, no precipitation; ③Good processing function, non-volatile and non-decomposing at the processing temperature of high polymer; ④Good resistance to extraction, insoluble in water and oil; ⑤The color of itself is best to be colorless or light-colored, so as not to pollute the product; ⑥Non-toxic or low-toxic; ⑦Low price. In fact, any kind of antioxidant can not fully meet these conditions.

HCFC-141b (monofluorodichloroethane) is a high-purity liquid widely used in cleaning and solvent fields. Because its damage to the ozone layer is 1/10 of CFC-113, it is designated as an ideal substitute for fully halogenated chlorofluorocarbons. HCFC-141b is a widely used non-perhalogenated chlorofluorocarbon. Although its destructive effect on the ozone layer has been greatly reduced compared to fully halogenated chlorofluorocarbons, it can still cause damage to the ozone layer that is difficult to recover. As a result, its use is gradually being reduced around the world.

M-xylene is an organic compound with a molecular formula C8H10, a molecular weight of 106, a colorless concussion liquid, a odor like toluene.

It is a solvent for a variety of coatings and a raw material for preparing dibutyl phthalate, a plasticizer. It is also used in the manufacture of butyl acrylate, butyl acetate, ethylene glycol butyl ether,

It is a solvent for a variety of coatings and a raw material for preparing dibutyl phthalate, a plasticizer. It is also used in the manufacture of butyl acrylate, butyl acetate, ethylene glycol butyl ether, as an extractant for organic synthesis intermediates and biochemical drugs, and in the manufacture of surfactants.N-butanol is a colorless, transparent and alcoholic liquid.

Oxygen is a simple substance composed of oxygen. The chemical formula O2 has more vivid chemical properties, and most of the elements can react with oxygen.

Sodium Persulfate is also called sodium sulfate, is an inorganic substance, a chemical formula is Na2S2O8, and the appearance is a white crystal powder, odorless.

Titanium dioxide is an inorganic, chemical formula TiO2, white solid or powdered amphoteric oxide, molecular weight 79.9, has non-toxic, optimal opacity, optimal whiteness and brightness, is considered to be the best in the world today A white pigment.

Molecular weight: 65.39 Grade: 5N MDL number: MFCD00011291 EC number: 231-175-3

HCFC-141b (monofluorodichloroethane) is a high-purity liquid widely used in cleaning and solvent fields.